Table of Contents
Advertisement
Available languages
Available languages
Fixture Settings
It is possible to change the parameter values in the
following ways:
DIMMER
•
Enter in Dimmer mode to select specific dim-
ming curve, press the button MENU so many
times until shows Dimmer Mode, and press the
button ENTER to confirm.
•
Press the button UP/DOWN to select Off - Dim-
mer 1 - Dimmer 2 - Dimmer 3.
•
Press ENTER button to store, then press MENU
to return to main menu.
BACKLITE
•
To activate Blacklight display press the button
MENU so many times until shows Back Light,
and press the button ENTER to confirm.
•
Press the button UP/DOWN to selec 0n - 10s -
20s - 30s.
•
Press ENTER button to confirm the selection,
then press MENU to return to main menu.
LED FREQUENCY
•
To adjust the frequency of the LEDs, press
the MENU button repeatedly until the display
shows LED Frequency, and then press the EN-
TER button.
•
Select the frequency (600Hz - 25kHz) using the
UP/DOWN buttons.
•
To confirm, press the ENTER key, then press
MENU to return to main menu.
Fixture Information
FIXTURE HOURS
Show the fixture working hours.
•
Press the button MENU so many times until
shows Information. Press the button ENTER to
confirm.
Design and product specifications are subject to change without prior notice.
P. 16
Neo Proton IP 12 QA -
English version
•
Using the button UP/DOWN to select Fixture
Hours, then press the button ENTER to confirm.
•
Then the display will show the working hours.
Press MENU to return ro main menu.
VERSION
Show the fixture firmware version.
•
Press the button MENU so many times until
shows Information.
•
Select through the button UP/DOWN the Ver-
sion menu voice.
•
The display will show firmware data. PRess
MENU to return to main menu.
TEMPERATURE
•
To read the value of the internal temperature of
the device, press the MENU button repeatedly
until the display shows Temperature, and then
press ENTER button to read the value.
•
Press the MENU button to go back or wait a few
seconds to exit the setup menu.
Amber Balance
Enter the White balance to adjust the Red, Green,
and Blue levels to achieve different whites.
•
Press the button MENU so many times until
shows Amber Balance, and press the button
ENTER to confirm.
•
Select the color R, G, B, A using the UP/DOWN
buttons, the press ENTER.
•
Using UP/DOWN button, select the desired color
value 125-255.
•
Press ENTER button to continue to the next
color R, G, B, A.
•
Continue until the desired mix is obtained.
•
Press the MENU button to go back or wait a few
seconds to exit the setup menu.
Advertisement
Table of Contents
