Change The Settings Of The Vacuum Compartment; When Opening/Closing The Door Of The Vacuum Case - Hitachi R-XG480KH Manual

Change the settings of the Vacuum Compartment

Touch
1
All indicator lamps turn on, and then the current settings are displayed.
2
Touch
The display switches in sequence as shown below every time the button is touched.
The temperature is set to " -1˚C (Subzero) " at the time of purchase.
Caution ● The " Off " indicator lamp continues to be lit during the " Off " operation. The display will be turned off
" -1˚C "
(At the time of purchase)
※ The above values are obtained with an ambient temperature of 32˚C, the temperature in the Vacuum compartment in a stable state with no
food stored and no door opened.

When opening/closing the door of the Vacuum Case

When opening the door
Pull up the
1
handle to
unlock.
※ It takes about three to four minutes for the Vacuum Case
to be vacuumed after the vacuum pump starts to operate.
The hissing sound may not be heard when the Vacuum
Case is opened within
four minutes.
※ If you pull out the
Vacuum Case without
opening the door on the
left/right, it may cause
damage to parts.
2
Pull out the
Vacuum Case.
※ The hissing sound indicates that vacuum is being
released. Thus, the Vacuum Case cannot be drawn out
while the sound is heard. Draw it out after the sound is no
longer heard.
Request
● If a part of the gasket is stuck together, the vacuum state cannot be maintained. If it is stuck together,
please remove it. Since it is difficult to see the left and right sides and the bottom, remove the Vacuum
Chilled Case and check it.
● Dew and/or frost may be formed in the sealed Vacuum Compartment due to moisture contained in food or in
the air. Soak a soft cloth in lukewarm water and wipe off the dew and/or frost with the cloth. (Attached dew,
frost or ice does not reduce performance.)
● If you want to avoid dew, frost or ice, stored food should be wrapped with plastic wrap.
● Wipe water or soup spilled in the compartment soon, if any.
● The platinum catalyst needs no replacement. Do not remove it.
BB0055761S_R-XG480KH_A.indd 51
button on the Control Panel to turn on the indicator lamp.
button to change the settings as you like.
after about 40 seconds for energy saving, but the function that is set once will remain effective.
" +1˚C "
Non-vacuum (-1˚C)
Handle
Hiss
Vacuum Case
Pg.66
" Off "
When closing the door
Push the Vacuum
1
Case back to the
end.
2
Press down the
handle to lock.
Caution
● The Vacuum Case is not
put in the vacuum state
unless the handle is
pushed down securely.
● Closing the door
of the Refrigerator
Compartment without
locking the handle may
damage parts or food or form a clearance between the
doors, which reduces cooling performance.
Touch it
A part stuck together
Gasket
Dew, frost or ice
51
19.9.30 2:27:53 PM