2. introduction
unique and innovative 360° swivel and tilt function enables the light source to be positioned in any direction. includes two 3.7V 2,600mAh
rechargeable li-ion batteries in parallel for up to 14 hours run time. each lamp houses 16 smd leds providing up to 600 lumens output with
120° spread of light, illuminating the whole work area. includes an additional 3W led in the end for use as a directional torch. features two
swivel hooks and three rubber covered magnets, two on the rear and one on the end, which allow hands free operation. supplied with usB
lead, mains plug and in-car charger.
3. specification
model no: ........................................................led360plus
Battery: ............................................. 3.7V - 2.6Ah li-ion (x2)
led quantity: .............................................. 16 smd + 1 led
lumen output side(high/low)/top: ................. (700/350)/150lm
operating time side(high/low)/top: .........................(6/12)/15hr
charging time: ...................................................................7hr
minimum length: ......................................................... 256mm
maximum length: ........................................................ 276mm
iP rating:..........................................................................iP54
important WArrAntY informAtion
V
The battery fitted to this lamp is considered to be a consumable item and its ability to accept a charge will reduce over time.
We will provide warranty against mechanical and electrical defect for a period of one year - this does not cover fair wear and tear.
If the battery is not properly charged before first use, or regularly conditioned, its capacity will diminish. Under these circumstances
we will not replace the battery regardless of whether it is less than one year old.
note: the lithium battery does not suffer from memory effect and once fully charged may be stored for up to six months without
another charge.
4. operation
4.1.
connect the usB lead to the charger unit and the socket on the rear of the lamp. Plug into power supply and turn on, the charging
LEDs on the lamp will flash green to show that charging has commenced.
4.2.
The number of green lights flashing indicate the level of charge
4.3.
When the battery has charged fully all the leds will show steady green
4.4.
direct the lens away from your eyes before switching on.
4.5.
toggle the lamp between the end light and side light using the on/off switch.
4.6.
the output of the side led can be varied by pressing the switch a further time.
4.7.
the lamp may be suspended by the hooks or attached to any ferrous surface by using the magnets. When the light is hanging from
the hook it can be rotated through 360° for more precise positioning.
4.8.
separate the top and bottom sections by pulling apart. When attached to a ferrous surface, using the base magnet, the lamp can
be rotated to shine in any direction.
© Jack sealey limited
Original Language Version
led360Plus series| issue: 2 02/03/17