Table of Contents
Advertisement
5
Where To Install The Speciality Unit
Place the speciality unit as close as possi-
ble to the pressure tank (well system) or
water meter (city water).
Place the Speciality System as close as
possible to a floor drain, or other accepta-
ble drain point (laundry tub, sump, stand-
pipe, etc.).
Connect the Speciality System to the main
water supply pipe BEFORE the water heat-
er.
DO NOT RUN HOT WATER
THROUGH THE SPECIALITY SYSTEM.
Temperature of water passing through the
Speciality System must be less than 100
deg. F.
Keep outside faucets on hard water to
save soft water and salt.
Do not install the Speciality System in a
place where it could freeze. Damage
caused by freezing is not covered by
the warranty.
Put the Speciality System in a place water
damage is least likely to occur if a leak de-
velops. The manufacturer will not repair or
pay for water damage.
A 120 volt electric outlet, to plug the in-
cluded transformer into, is needed within 6
feet of the Speciality System. The trans-
former has an attached 6 foot power ca-
ble. Be sure the electric outlet and
transformer are in an inside location,
to protect from wet weather.
If installing in an outside location, you
must take the steps necessary to assure
the Speciality System, installation plumb-
ing, wiring, etc., are as well protected from
the elements, contamination, vandalism,
etc., as when installed indoors.
Keep the Speciality System out of di-
Special Unit
Advertisement
Table of Contents
