Guardzilla 360 Outdoor Manual

Factory re-setting and power cycling

FACTORY RE-SETTING AND

YOUR GUARDZILLA CAMERA

______________________________________________________________

1) Factory reset your camera;

Power Cycling Your Camera will retain all your settings. It's a good first step if you are experiencing issues

with your camera. A factory reset of your camera will remove all of your camera's settings and will require

you to set up your camera all over again.

______________________________________________________________

Make sure that your camera is on. IF the status LED light on the top of the camera is off, press the

power button to activate the camera.

Locate the power button on the side of the camera.

Press down and hold the power button while watching the LED light on the top of the camera until it

begins to blink red and blue, then release the button. Your camera will now go through the factory reset

process. In a few seconds the camera will announce that "Guardzilla 360 is initialized". Your camera is

reset and can now be added back onto your network (see STEP 4 below), if desired.

POWER CYCLING

This guide describes how to:

FACTORY RE-SETTING YOUR CAMERA

and

2) Power cycle your camera.

Guardzilla 360 Outdoor

Table of Contents

Need help?

Do you have a question about the 360 Outdoor and is the answer not in the manual?

Page 1 Your camera will now go through the factory reset process. In a few seconds the camera will announce that “Guardzilla 360 is initialized”. Your camera is reset and can now be added back onto your network (see STEP 4 below), if desired.
Page 2 To add your camera back onto your new network follow these steps: STEP 1. On the upper right hand corner of your Guardzilla app’s home screen press the blue plus (+) sign. STEP 2. A carousel of product images will appear. Swipe your finger on the product images until the Outdoor Live Video Security Camera image and title appears, then select Next and follow the directions for adding a camera back to your system.