Guardzilla 360 Indoor User Manual

FACTORY RE-SETTING AND
YOUR GUARDZILLA CAMERA
______________________________________________________________
1) Factory reset your camera;
Power cycling your camera will retain all your settings. It's a good first step if you are experiencing issues
with your camera. A factory reset of your camera will remove all of your camera's settings and will require
you to set up your camera all over again.
______________________________________________________________
1
Get a paper clip or other slim metal tool.
. 2
First, confirm that your camera is plugged in, then insert the end of the paper clip into the hole on the
bottom of the camera next to the word "Reset". Gently push down until you feel the button inside the
hole depress, then hold the button down for approximately 7 seconds until the light ring on top of the
camera starts blinking red and blue. Once the lights start blinking red and blue, remove the paper clip.
. 3
After you have removed the paper clip your camera will now go through the factory reset process.
When your camera is finished resetting, the light ring will blink red for several seconds, then blink blue
and announce that "Guardzilla 360 is initialized". Your camera is reset and can now be added back onto
your network (see Step 4 below), if desired.
POWER CYCLING
This guide describes how to:

FACTORY RE-SETTING YOUR CAMERA

and 2) Power cycle your camera.
RESET
Guardzilla 360 Indoor