Guardzilla 180 Indoor How To Reset

FACTORY RE-SETTING AND

YOUR GUARDZILLA CAMERA

______________________________________________________________

1) Factory reset your camera;

Power cycling your camera will retain all your settings. It's a good first step if you are experiencing issues

with your camera. A factory reset of your camera will remove all of your camera's settings and will require

you to set up your camera all over again.

______________________________________________________________

Make sure that your camera is plugged in.

Locate the RESET button on the back of your camera.

Press the RESET button and hold it down. Wait a few seconds for the LED light on the top of the

camera to blink red and blue, then release the button. Your camera will now go through the factory

reset process. When it finishes re-setting the LED will start blinking green. The camera can now be

added back onto your network (see Step 4 below), if desired.

POWER CYCLING

This guide describes how to:

FACTORY RE-SETTING YOUR CAMERA

and

2) Power cycle your camera.

Guardzilla 180 Indoor

Table of Contents

Need help?

Do you have a question about the 180 Indoor and is the answer not in the manual?

Page 1 Guardzilla 180 Indoor FACTORY RE-SETTING AND POWER CYCLING YOUR GUARDZILLA CAMERA ______________________________________________________________ This guide describes how to: 1) Factory reset your camera; 2) Power cycle your camera. Power cycling your camera will retain all your settings. It’s a good first step if you are experiencing issues with your camera.
Page 2 To add your camera back onto your new network follow these steps: STEP 1. On the upper right hand corner of your Guardzilla app’s home screen press the blue plus (+) sign. STEP 2. A carousel of product images will appear. Swipe your finger on the product images until...