Advertisement
Assembly
1. Remove all parts from the shipping container(s).
Remove all packing material from the parts. Recycle
shipping and packing materials in accordance with the
recycling codes of your location.
Move the side frames apart and pull forward on the Fold
Frame Pull Pin until the fold frame locks into place
2. Place the front seat snap brackets onto the front seat
support tubes and than place rear seat snap brackets
onto the rear seat support tubes.
Make sure that the seat is square, and all 4 corners are
snapped into place before sitting on chair.
Front Snap Bracket
3. Loosen then remove the self-locking nut and screw that
are in the chair frame where the back assembly will be
attached and set aside.
Tools required for setup: 3/4" wrench, 3/4" socket wrench, 7/16" wrench,
#10 metric wrench, 5/32" hex key
Rear Snap Bracket
Fold Frame Pull Pin
3
Advertisement
