Table of Contents
Advertisement
& Extreme Memory Profile (X.M.P.)
Allows the BIOS to read the SPD data on XMP memory module(s) to enhance memory performance when
enabled.
Disabled
Disables this function. (Default)
Uses Profile 1 settings.
Profile1
Uses Profile 2 settings.
(Note)
Profile2
& System Memory Multiplier DDR4-2133
Allows you to set the system memory multiplier. Auto sets memory multiplier according to memory SPD
data. (Default: Auto)
& Memory Ref Clock
Allows you to manually adjust the memory reference clock. (Default: Auto)
& Memory Odd Ratio(100/133 or 200/266)
Enabled allows Qclk to run in odd frequency. (Default: Auto)
& Memory Frequency (MHz)
The first memory frequency value is the normal operating frequency of the memory being used; the second
is the memory frequency that is automatically adjusted according to the System Memory Multiplier settings.
` PC Health Status
& Reset Case Open Status
Disabled
Keeps or clears the record of previous chassis intrusion status. (Default)
Clears the record of previous chassis intrusion status and the Case Open field will
Enabled
show "No" at next boot.
& Case Open
Displays the detection status of the chassis intrusion detection device attached to the motherboard CI
header. If the system chassis cover is removed, this field will show "Yes", otherwise it will show "No". To
clear the chassis intrusion status record, set Reset Case Open Status to Enabled, save the settings to
the CMOS, and then restart your system.
& CPU Vcore/CPU VCCSA/DRAM Channel A/B Voltage/+3.3V/+5V/+12V/CPU VAXG
Displays the current system voltages.
& CPU/System/2nd System/PCH
Displays the current temperature of the selected target area.
& CPU/System 1/System 2 Fan Speed
Displays current CPU/system fan speeds.
& CPU/System/PCH Temperature Warning
Sets the warning threshold for CPU/system/Chipset temperature. When temperature exceeds the threshold,
BIOS will emit warning sound. Options are: Disabled (default), 60
90
C/194
F.
o
o
& CPU/System 1/System 2 Fan Fail Warning
Allows the system to emit warning sound if the fan is not connected or fails. Check the fan condition or fan
connection when this occurs. (Default: Disabled)
& CPU Fan Control Mode
Lets the BIOS automatically detect the type of fan/pump installed and sets the optimal
Auto
control mode. (Default)
Voltage mode is recommended for a 3-pin fan.
Voltage
PWM mode is recommended for a 4-pin fan.
PWM
(Note)
This item is present only when you install a CPU and a memory module that support this feature.
(Note)
- 25 -
C/140
F, 70
C/158
F, 80
C/176
o
o
o
o
o
F,
o
Advertisement
Table of Contents
