Gigabyte C246N-WU2 User Manual page 11

HDMI Port
The HDMI port supports HDCP 2.2 and Dolby TrueHD and DTS HD Master Audio
formats. It also supports up to 192KHz/16bit 8-channel LPCM audio output. You
can use this port to connect your HDMI-supported monitor. The maximum supported resolution is
4096x2160@30 Hz, but the actual resolutions supported are dependent on the monitor being used.
• To set up a triple-display configuration, you must install motherboard drivers in the operating
system first.
• After installing the DisplayPort/HDMI device, make sure to set the default sound playback
device to DisplayPort/HDMI. (The item name may differ depending on your operating system.)
RJ-45 LAN Port
The Gigabit Ethernet LAN port provides Internet connection at up to 1 Gbps data rate. The following
describes the states of the LAN port LEDs.
Connection/
Connection/Speed LED:
Speed LED Activity LED
State
Orange
Green
Off
LAN Port
USB 3.1 Gen 1 Port
The USB 3.1 Gen 1 port supports the USB 3.1 Gen 1 specification and is compatible to the USB 2.0
specification. Use this port for USB devices.
Mic In (Pink)
The Mic in jack.
Line Out/Front Speaker Out (Green)
The line out jack.
• When removing the cable connected to a back panel connector, first remove the cable from your
device and then remove it from the motherboard.
• When removing the cable, pull it straight out from the connector. Do not rock it side to side to
prevent an electrical short inside the cable connector.
• The integrated HD (High Definition) audio provides jack retasking capability that allows the user
to change the function for each jack through the audio driver.
• To configure 7.1-channel audio, you have to use an HD front panel audio module and enable the
multi-channel audio feature through the audio driver. Please go to the Start menu to select Realtek
Audio Console, enter the Device advanced settings tab in the lower left corner of the dialog box,
and check the option Mute the internal output device, when an external headphone plugged
in. to proceed with 7.1-channel settings.
Please visit GIGABYTE's website for details on configuring the audio software.
Activity LED:
Description State
1 Gbps data rate Blinking
100 Mbps data rate On
10 Mbps data rate
- 11 -
Description
Data transmission or receiving is occurring
No data transmission or receiving is occurring