HUSABERG FE 450 AUS 2009 Setup Instructions page 6

SET‑UP
–
Position the mirror clamp
–
Position the clutch master cylinder and tighten the screw.
–
Mount both rear mirrors.
–
Tighten the screws of the mirror clamp.
100472-10
–
Position the brake line and wiring harness in brake line guide
–
Insert the distance bushings in the brake line guide. Position the fender with the
brake line guide.
–
Mount and tighten screws.
Guideline
Remaining screws, chassis
100473-10
–
Position fender brace
–
Mount and tighten the screws on the lower triple clamp and on the fender.
100474-10
–
Position the speedometer
screws.
Guideline
Remaining screws, chassis
100475-10
–
Connect the flasher.
Guideline
Flasher, front right
Flasher, front left
–
Connect all connectors to the connector board.
–
Plug the sockets of the indicator lamps into the corresponding lamp housing.
Guideline
Flasher indicator lamp
100476-10
FI Warning lamp (MIL)
–
Fix the cable with cable binders (for routing, see figure).
–
Install the headlight mask with the headlight. (
–
Install the front wheel. (
.

M6
with the flasher.

and connector board
 
M6
Connector CX, brown/black
Connector CX, brown/purple
Purple/black
White/orange
p. 6)
p. 6)
.

10 Nm (7.4 lbf ft)
. Mount and tighten the
10 Nm (7.4 lbf ft)
4