Dyna-Glo EG10000DH User's Manual And Operating Instructions page 11

OPERATING INSTRUCTIONS
The heater must be properly installed before it is used.
Check that the garage heaters outlet grill is not covered or obstructed in
anyway, and make sure the power to the unit is switched on.
The fireplace control functions can be accessed in two (2) ways:
• Using the touchpad control panel, located in the upper right-hand corner of
the fireplace behind the sliding
control panel cover.
• Using the multifunction remote control unit.
1. Main Power Button:
This button supplies power to all of the garage heaters functions. It must be turned on
for the garage heater to work
2. Heater Control Button:
This button adjusts the 3 heating stages: OFF Fa (Fan Only) LOW (7500W displays
"L"), High (10000W displays "H").
3. Temperature/Timer Display:
This LED display shows the set point for the temperature and timer functions. When
either of these functions is activated, the display reflects the set point for five
seconds and then fades to black. Any change to he set point of the temperature or
timer will reactivate the display, which again fades after five seconds.
WARNING
11