Table of Contents
Advertisement
Setting up
Follow these steps to set up your Synergy 2150 ready for use.
Plan the location of your
Synergy 2150
Your Synergy 2150 works by sending
and receiving radio signals between
the base station and the handset.
The strength of the signal can depend
on where you site the base station.
Generally, the higher the base station
is located the better. An upstairs room
is ideal.
The following points should be
considered:
• It should be within 3 metres of a
power socket and phone socket
otherwise extension cables will be
required.
• Try to avoid locations near metallic
obstructions or electrical appliances,
such as TV sets, fridges, computers,
fluorescent lights, radiators, metal
pipes and metal window frames.
Please note
The Synergy 2150 has a range of
up to 300 metres outdoors and up to
50 metres indoors. It is possible that
the range may be affected by being
near water (e.g. large ponds, lakes
and the sea) as well as large metal
objects (e.g. radiators, metal partition
walls and steel girders).
1
Connect the power cable
Plug the power cable into the power
socket on your Synergy base station.
Plug the adaptor into the mains power
supply and switch on. The power light
comes on and starts to flash. This will
continue flashing until the Day & Time
are set (see page 22).
Install the rechargeable
2
battery in the handset
The Synergy 2150 uses a nickel metal
hydride (NiMH) battery pack supplied.
Take care to connect the battery as
shown and replace the battery cover.
10
Advertisement
Table of Contents
