Advertisement
Mini-Vault LTV761 Installation Instructions
INSTRUCTIONS PERTAINING TO A RISK OF FIRE, OR INJURY TO PERSONS
WARNING: Fixtures must be grounded in accordance with local codes or the National Electrical Code.
!
Failure to do so may result in serious personal injury.
SAFETY WARNING: Do not install these fixtures in submersible installations such as fountains or
!
swimming pools. Extreme caution should be taken when fixtures are used in paved areas. High
temperature lenses can burn feet, hands or objects inadvertently placed on top of fixtures. If fixtures must be
used in paved areas, locate them away from normal pedestrian traffic, and use the lowest wattage available.
Lighted lamp is HOT! Do not touch hot lens, guard or enclosure.
MAINTENANCE: To maintain light efficiency and prevent fixture overheating, lenses must be kept clean and free
of dirt, dust, leaves, trash and mineral deposits from water. For optimum performance a regularly scheduled
maintenance program should be followed. DO NOT operate luminaire with missing or damaged lens.
NOTE: All wiring should be done by a qualified electrician.
KEEP THIS SHEET FOR FUTURE REFERENCE.
CAUTION:
To help maintain a clean, dry splice compartment, seal the conduit entries with RTV.
Do not exceed maximum wattage shown on fixture label.
Tool Required:
Flat Head Screwdriver
!
Make certain electrical supply is OFF before starting fixture installations.
1. Excavate hole in desired location approximately
12" in diameter and about 3" deeper than the
height of fixture. Connect housing to conduit
system using a good thread sealant.
Revised 7/16/10
ECN 100715008
P.O. Box 60080 • 16555 East Gale Ave.
City of Industry, California 91716-0080
626/968-5666 • FAX 626/330-3861
IMPORTANT SAFETY INSTRUCTIONS!
F" Hex Wrench
Status 8
Thread Sealant
2. Backfill hole with sand/gravel and soil for stability.
Do not backfill hole with bark or vermicolite. (May
be installed in concrete, for paved area installation
use Trim Ring, part no. TR60.)
LTV761
RTV Sealant
Part No. 95597
Advertisement
Table of Contents
Related Manuals for Hubbell Mini-Vault LTV761
Summary of Contents for Hubbell Mini-Vault LTV761
- Page 1 P.O. Box 60080 • 16555 East Gale Ave. City of Industry, California 91716-0080 626/968-5666 • FAX 626/330-3861 Mini-Vault LTV761 Installation Instructions LTV761 INSTRUCTIONS PERTAINING TO A RISK OF FIRE, OR INJURY TO PERSONS IMPORTANT SAFETY INSTRUCTIONS! WARNING: Fixtures must be grounded in accordance with local codes or the National Electrical Code.
- Page 2 Mini-Vault LTV761 Installation Instructions Locking Screw Allen Head Screws (5) 3. To open fixture, remove five (5) 4. Loosen vertical locking screw. 5. Gently compress legs of socket allen head cap screws, lens (Do Not Remove) bracket inward and remove frame, lens and gasket.
- Page 3 Mini Vault - LTV761 Installatlion Instructions KIM LIGHTING LIMITED WARRANTY When installed in accordance with Kim Installation Instructions and accepted trade practices, the following shall apply: General Product Limited Warranty Coverage All material and component parts used in the manufacture of Kim Products, are warranted to be free from defects of material and/or workmanship for a period of 1 year from date of sale, with the following exceptions: Auxiliary Equipment...
Need help?
Do you have a question about the Mini-Vault LTV761 and is the answer not in the manual?
Questions and answers