Hubbell KIM LIGHTING KLV360 Installation Instructions

Mini Vault - LTV765/766 & KLV360/361/365/366
Installation Instructions
INSTRUCTIONS PERTAINING TO A RISK OF FIRE, OR INJURY TO PERSONS
WARNING: Do not overdrive fixtures with greater than 12 volts or fixture over-heating and short lamp life
!
will occur. This can happen when using other than KIM KLV model transformers.
SAFETY WARNING: Low voltage fixtures can become very hot depending on the lamp wattage used.
!
Glass lenses and metal areas above and around the lamp can become hot enough to blister hands. DO
NOT touch the lamp at any time. Particular care should be taken not to locate fixtures where small children can
reach them if higher wattages are used. Lighted lamp is HOT!
CAUTION: Lamp gets HOT quickly. When relamping fixture avoid touching the lamp envelope with bare hands. If
touching the lamp is necessary during installation, clean the envelope with alcohol and dry with a clean, soft
cloth before burning. Contamination of the envelope may reduce lamp performance.
MAINTENANCE: To maintain light efficiency and prevent fixture overheating, glass lenses and enclosures must
be kept clean and free of dirt, dust, leaves, trash and mineral deposits from water. Do not use these fixtures in
submersible installations such as fountains or swimming pools. Do not install luminaire within 10 feet (1.52m) of
a pool, spa, or fountain. Keep away from materials that may burn. DO NOT operate luminaire with missing or
damaged lens.
NOTE: Keep the lamp free from impact while burning, as this may deform the filament and shorten the lamp life.
All electrical work should be done by a qualified electrician. NOT INTENDED FOR INDOOR USE.
KEEP THIS SHEET FOR FUTURE REFERENCE.
CAUTION:
Do not exceed maximum wattage shown on fixture label.
Tools Required:
Flat Head Screwdriver
!
Make certain electrical supply is OFF before starting fixture installations.
1. Excavate hole in desired location
approximately 12" in diameter and
about 3" deeper than height of
fixture.
Revision 7/16/10 ECN 100715008
P.O. Box 60080 • 16555 East Gale Ave.
City of Industry, California 91716-0080
626/968-5666 • FAX 626/330-3861

IMPORTANT SAFETY INSTRUCTIONS

F" Hex Wrench
2. Backfill hole with sand/gravel and
soil for stabiity. Do not backfill with
bark or vermicolite. (May be
installed in concrete, for paved
area installation use Trim Ring,
part no. TR60.)
Status 13
LTV765/766
KLV360/361
Socket Head
Cap Screw (5)
Socket Head
Cap Screw (5)
3. To open fixture, remove five (5)
socket head cap screws, lens
frame, lens and gasket.
KLV365
KLV366
Part No. 95598