Precautions - Philips ADD4966 User Manual

(2) Flushing the lter for rst time usage
· Unplug the lter drain at the back of the dispenser, and
connect the lter drain with the PE pipe provided. Put
the other end of the PE pipe in a container or a bucket
which can hold at least 5L water.
· Plug the water dispenser into a grounded power outlet. Insert the stainless steel pipe into the
bottle, and slide the bottle in. Close the cabinet door. Water that is used to ush the lter will
ow into the container automatically from the lter drain. Flush the lter for 3 minutes.
· Once it's done, open the cabinet door, remove the PE pipe from the lter drain and plug the
lter drain.
· Close the cabinet door. Now the lter is ready to use.
(3) Replacing the lter and resetting lter lifetime indicator
· Open the cabinet door and remove stainless steel pipe
from the bottle. Press the cold water button to empty
the water tank inside.
· Turn the lter counterclockwise to take o the old lter.
· Screw the new lter clockwise into the lter holder until
the dots on the lter and the holder is fully aligned.
· Press and hold the reset button for 5 seconds to reset
the lter lifetime indicator. Once successful, the lter lifetime indicator on the panel will
switch o .
· Flush the lter as instructed above.
· If you reset the lifetime by mistake, continuously short press the reset button for 5 times
within 5 minutes, then the lter lifetime indicator will ash for 3 times which means you
revoke the reset successfully.
UV-LED light (applicable for ADD4969)
The UV-LED light is installed in the cold water tank to kill the bacteria which may grow inside.
It's controlled automatically by the software program once the dispenser is connected
with power.

5 Precautions

Warning
When using electrical appliances, basic safety precautions should be followed to reduce the
risk of re, electric shock, and injury to persons or property. Read all instructions before using
any appliance.
6
Dispenser ushing drain
Filter drain
Filter reset button
Filter