ASC SP009 Instructions

SP009 Solar Water Pump Kit Instructions
By All Solar Central
www.allsolarcentral.com
Thank you from the entire ASC family for purchasing
an ASC solar product! Please read this entire booklet
before assembly.
Package contents:
1 x Water Pump with 16 ft. Cable
1 x LED Light Ring with 16 ft. Cable
1 x Battery Control Box
2 x Solar Panel with 6.5 ft. Cable
2 x Solar Panel Bracket
4 x Extension Tube
2 x Ground Spike
1 x Set of Fountain Nozzles
1 x Remote Control (Remote Control Version Only)
Notes: If there is any damage to the product or missing
parts, please contact us at 1-626-582-8898 or
www.allsolarcentral.com/contactus

Assembly Steps:

1. Connect the bracket, tubes and spike together.
Then attach the solar panel to the bracket. Slide
the holding bracket into the inside lip of the top
half of the solar panel frame. The bracket holds
the weight of the solar panel. The solar panel can
be adjusted for optimal sunlight by using the
wingnut. Please see the diagram.
2. Insert the spike into the ground. Position the
solar panel so it's facing south (in northern
hemisphere) as much as possible to maximize
daylight hours. It is important to angle the solar
panel to face the sun when the sun is at its
highest point. Ensure the solar panel is not
shaded by trees, shrubs or buildings.
3. Connect the Solar Panel, LED Light, and Pump to
the Battery Control Box (See diagram below:)
IMPORTANT!!
Slightly twist the connectors when connecting to
make sure the rubber seals are fully in the
grooves.
4. The assembled Solar Pump should look like this:

5. BATTERY CONTROL BOX OPERATION

Note: LED light is designed to work at night only
1