ASC SP006 Instructions

SP006 Solar Water Pump
Instructions
By All Solar Central
www.allsolarcentral.com
Thank you from the entire ASC family for purchasing
an ASC solar product! Please read this entire booklet
.
before assembly

Package contents:

1 x Water Pump with 16 ft. Cable
1 x LED Light Ring with 16 ft. Cable
1 x Battery Control Box
1 x Set of Fountain Nozzles
1 x Solar Panel with 6.5 ft. Cable
1 x Solar Panel Bracket
2 x Extension Tube
1 x Ground Spike
Notes: If there is any damage to the product or missing
parts, please contact us at 1-626-582-8898 or
www.allsolarcentral.com/contactus

Assembly Steps:

1. Connect the bracket, tubes and spike together.
Then attach the solar panel to the bracket. Slide
the holding bracket into the inside lip of the top
half of the solar panel frame. The bracket holds
the weight of the solar panel. The solar panel can
be adjusted for optimal sunlight by using the
wingnut. Please see the diagram.
2. Insert the spike into the ground. Position the
solar panel so it's facing south (in northern
hemisphere) as much as possible to maximize
daylight hours. It is important to angle the solar
panel to face the sun when the sun is at its
highest point. Ensure the solar panel is not
shaded by trees, shrubs or buildings.
3. Connect the pump, LED Light to the Solar Panel
(See diagram below:)
IMPORTANT!!
Slightly twist the connectors when connecting to make
sure the rubber seals are fully in the grooves.
4. The assembled Solar Pump should look like this:
5. PUMP ASSEMBLY: This pump is designed to be
used in different depths of water. In shallower
pond/reservoirs please make sure there is
1