Download Print this page

Lakes SS70 Installation & Maintenance Instructions Manual

Framed (folding) bathscreens

Advertisement

Quick Links

FRAMED (Folding) BATHSCREENS
Installation & Maintenance Instructions
rev 01.19
Models Covered :
SS70 ~ SINGLE PANEL
SS75 ~ TWIN PANEL
SS80 ~ TRIPLE PANEL
SS85 ~ FOUR PANEL

Advertisement

loading

Summary of Contents for Lakes SS70

  • Page 1 FRAMED (Folding) BATHSCREENS Installation & Maintenance Instructions rev 01.19 Models Covered : SS70 ~ SINGLE PANEL SS75 ~ TWIN PANEL SS80 ~ TRIPLE PANEL SS85 ~ FOUR PANEL...
  • Page 2: Important Notes

    However should maintenance be required it should be carried out by a competent person with reference to these instructions. Before any work is carried out the root cause of the problem must be identified. Lakes Bathrooms service engineers are available if necessary to consult / carry out remedial work. Call Lakes Bathrooms HELPLINE.
  • Page 3: Supplied Parts

    SUPPLIED PARTS : Screen Sub Assembly: Single Twin Triple Four Panel Panel Panel Panel Comprising (replaceable parts) : Hinge Half Wall Hinge (Male) (2x) Hinge Rail Hinge Half (Wall side) (Female) Hinge Bearing (2x) Corner Piece Hinge Seal (2x) M3,5 x 40 long Pan Head (2x) Pozi Drive Screw &...
  • Page 4 The use of good quality silicone sealant & cleaning / degreasing of all joint areas is recommended. Lakes fully reversible Framed (folding) Bathscreen for fitting left or right handed to flat top bathtub. Ensure bath rim is level & that bath / wall (tile) joints are sealed & cured over entire length of bath sides (See Fig A) prior to fitting screen.
  • Page 5 Multi panel screens can be folded flat to the mounting wall. Before fitting, the folding direction & stowage hand should be determined by reversing the screen (top to bottom) for the preferred orientation. 1. Carefully lift screen into position & push into wall profile.
  • Page 6 Check screen functions: Folds flat to wall & extends/locks to straight position (shown). Check that bottom seal(s) are in contact with bath rim over entire length. Move screen inward over bathtub & apply continuous bead of silicone sealant as indicated EXTERNALLY ONLY.
  • Page 7: Basic Troubleshooting

    / bottom hinge ONLY. Water / moisture appearing outside this area (ie under the bathtub or at floor level) is normally due to incorrect bathtub installation / sealing. Lakes Bathrooms Ltd Lakes Bathrooms Ltd Service : Northern Ireland...

This manual is also suitable for:

Ss75Ss80Ss85