Bar Tack Stitch - Necchi NC-102D Instruction Manual

Bar tack stitch

Bar tack stitch is used to reinforce points subject to strain, such as pocket corners and
openings.
29
1
1
1
Using the buttonhole foot.
Extend the button holder plate and set to the
desire length. Adjust the stitch width and the
stitch length to the desired width and density.
Attach the buttonhole foot. The thread should
be passed through the hole in the presser
foot, then be placed under the foot.
①
Button holder plate
Position the fabric so that the needle is 2mm
in front of where you want the sewing to start,
and then lower the presser foot lifter.
①
2mm
②
Starting point
2
Pull the buttonhole lever all the way down
and position it behind the bracket on the
buttonhole foot.
Slightly hold the end of the upper thread and
start sewing.
①
Buttonhole lever
②
Bracket
2
Bar tack stitches are sewn.
It is suggested that you sew with a
stabilizer material under the fabric.
51
Note