Table of Contents
Advertisement
Connecting machine to power source
1
Always make sure that the machine is
unplugged from power source and the main
switch is off ("O"), when the machine is not
in use and before inserting or removing
parts.
Before connecting the power supply, make
sure that the voltage shown on the rating
plate is conforming with your main power.
Put the machine on a stable table.
1. Connect the machine to a power source
as illustrated.
2. Turn the power switch to on ("I").
2
The sewing lamp will light up when the switch
OFF
ON
is turned on.
v Polarized plug information
This appliance has a polarized plug (one
blade is wider than the other), to reduce the
risk of electrical shock; this plug will fit in a
polarized outlet only one way. If the plug does
not fit fully in the outlet, reverse the plug. If it
still does not fit, contact a qualified electrician
to install the proper outlet. Do not modify the
plug in any way.
v Foot control
When the machine is off, insert the foot
control plug into its connector on the machine.
Turn on the machine, and then slowly press
down the foot control to start sewing. Release
the foot control to stop the machine.
v Foot controller with needle up
and down feature
User can quickly press one step on the foot
controller to change the needle position go up
or down into the fabric.
Consult a qualified electrician if in doubt
as to connect the machine to the power
source.
4
n Attention
Note
Advertisement
Table of Contents
