Necchi NC-102D Instruction Manual page 55

1
2
Pull the buttonhole lever all the way down
and position it behind the bracket on the
buttonhole foot.
①
Buttonhole lever
②
Bracket
Slightly hold the end of the upper thread and
start sewing. Pull two lines together.
Gently feed the fabric by hand.
Before stopping, the machine will
automatically sew a reinforcement stitch
after the buttonhole is sewn.
Raise the presser foot lifter and cut the
thread. To sew over the same buttonhole,
raise the presser foot lifter (it will return to its
original position).
After sewing the buttonhole stitch, raise the
buttonhole lever as far as it will go.
1
①
Buttonhole lever
Use the seam ripper to cut the center of
the buttonhole being careful not to cut any
stitches on either side. Use a pin as a stopper
at the bar tack so you do not cut too much.
When cutting the buttonhole with the seam
ripper, do not place your hands in the
cutting direction, otherwise injuries may
result.
49
Note
Note