T_Sen1~2: Thermal Sensor Connectors; Jslow1: Slow Mode Booting Jumper; Jln1: Low Temperature Booting Jumper - MSI MEG X570 GODLIKE Quick Start Manual

T_SEN1~2: Thermal Sensor Connectors

These connectors allow you to connect the thermistor cable and use it to monitor the
temperature of the detection point.

JSLOW1: Slow Mode Booting Jumper

This jumper is used for LN2 cooling solution, that provides the extreme overclocking
conditions, to boot at a stable processor frequency and to prevent the system from
crashing.

JLN1: Low Temperature Booting Jumper

This jumper is used for liquid nitrogen cooling system to boot at an extreme low
temperature. Try to set it Enabled to increase the boot success rate.
Important
Users will try extreme low temperature (must be higher than -124 degrees to prevent
y
Debug Code 00) overclocking at their own risks.
The overclocking results will vary according to the CPU version.
y
Please don't set to Enabled when the system is powered off or can't be started.
y
Sense
GND
JSLOW1
Normal
(Default)
JLN1
Normal
(Default)
Thermistor cable
Enabled
(Please enable this jumper
during BIOS POST.)
Enabled
(Please enable this jumper
during BIOS POST.)
Overview of Components
45