Put The Printer Into Sleep Mode; Wake The Printer From Sleep Mode; Reboot The Printer - Brady BradyPrinter i3300 User Manual

Put the Printer into Sleep Mode

When the system is asleep the display turns off and the system goes into a low power consumption
state but does not require a cold start to turn back on. In this state, you can either touch the screen or
press the power button to return the system to the same state it was in before going into lower power
consumption mode. When the printer is in sleep mode the power button is lit green.
Note: To fully shut down the printer press and hold the power button for longer than two seconds.
1. With the printer on, press and hold
2. If there are unsaved changes in the currently active file, you will be prompted to save the
current label file.

Wake the Printer from Sleep Mode

If you do not touch the screen or keypad for a defined period of time, the system turns off the display
and goes into a low-power consumption mode. When in Sleep Mode, the power button is lit green. The
current label and settings are retained.
1. Press
2. Continue with your label activities.

Reboot the Printer

Use this procedure to reboot the printer.
1. Press and hold
starts the printer.
2. When the Home page displays, you can continue with your label activities.
BradyPrinter i3300
or touch the screen.
for at least 5 seconds. The system performs the initialization process and
for approximately two seconds.
Setup
Power
6