Installing; Installing To The Wall - cabstone CAB EASYFIX U-Slim XL User Manual

User's manual
• The place of installation must be able to withstand earthquakes, or other strong vibrations.
• Avoid places with high temperatures, or humidity, or places which might come into contact with water.
• Do not install the product close to openings of air conditioners, or at places with an excessive amount of dust
or smoke.
• Install it only on a vertical wall. Avoid slant surfaces, because other kind of tensile stress may then interact with
the material.
• Do not install the product at places subject to vibration, or oscillation.
• Do not modify and alter any accessories! Make sure you also read the Chapter "Warranty and Liability". Do not
use any damaged parts.
• Tighten all screws. Do not use too much force to avoid breakage of screws and over-turning of threads.
• Drill holes are still visible on the wall after the device bracket and the cable management system is removed.
After use for a longer time period, a spot may remain on the wall.
• Do not install the product at places subject to direct solar radiation, or strong light. This will increasingly tire the
eyes while looking at the display. Keep sufficient space around the output devices, as well as audio / video
devices, and around the entire system to ensure proper ventilation and clearance, and to avoid damages.
• During transport, observe the details listed in the Chapter "Specifications", and implement measures suitable
for transport.
• For questions, defects, mechanical damages, malfunctions, and other functional problems which cannot be
resolved by this guide, please contact your dealer for repair or replacement, as described in the Chapter
"Warranty and Liability".
• The supplied components are only suitable for installation to a solid stone and concrete wall. If the structure of
your wall is different, corresponding installation material must be used. In any case, consult a specialist.
• Make sure to observe the correct thread size during installation of the display screen to the wall bracket.
5

Installing

5.1 Installing to the wall

1. Check before drilling, whether gas, water, or power lines are located behind the wall.
2. Use the template (D) for marking the holes in the wall . Use a spirit level.
3. Drill the holes with a 10mm masonry drill 60mm deep.
4. Plug a wall plug (W-B) into the drilled holes.
5. Attach the wall bracket (A) with the wall screws (W-A) and washers (W-C) in right distance.
Therefore attend to the fixing points at the back of your monitor.
Fig. 1: Marking
Page 4 / 8
CAB EASYFIX U-Slim XL
Fig. 2: Drilling
Fig. 3: Assembling the
wall plate