Advertisement
GETTING TO kNOW YOUR TOOL
1. Carrying case
2. 1/4" hex. drive quick release chuck
3. LED work light
4. Variable speed trigger
5. Forward/reverse switch
6. 20V MAX Li-ion cordless impact driver
7. 20V MAX Li-ion battery (1 of 2)
8. 20V MAX Li-ion battery charger
SPECIFICATIONS
Model ........................................................................................................................8022L
Voltage ................................................................................................................20V MAX
Battery type ............................................................................................1300m/Ah (li-ion)
Quick release chuck ..........................................................................................1/4" (hex.)
Speed range ..................................................................................................0-2000 RPM
Impacts per minute ..................................................................................................0-3300
Torque ..............................................................................................................1,350 in/lbs
Charger ..............................................................................................................45 minute
Figure 1
Not shown:
• Battery power level indicator
• Bit holder
• 4 nut drivers with 1/4" hex. shank,
6 screwdriver bits (Robertson #1 & #2,
Phillips #1 & #2, 5mm & 6mm flat),
bit extension
OPERATION
Using your 20V MAX Lithium-ion cordless impact driver
WARNING: Do not install battery until the accessory is
installed securely to the tool. Wear protective gloves
and safety glasses, an accessory can become extremely
hot during operation, danger of burns!
Charging the battery/battery level indicator
Both batteries come with a battery power level indicator
(A) Fig.2, press the button (B) to see the charge level. If
the battery level is low charge the battery. To charge the
battery (C) Fig.2, plug charger (D) power cord into a
120V AC receptacle (do not use extension cord). The
green LED (E) will flash to indicate power to the charger.
Align the grooves of the battery with those of the charger
and slide the battery all the way until it snaps into place.
The red LED (F) will light up indicating the charging
procedure has begun. Once the green LED (E) lights up,
the battery is fully charged and ready to use. Press the
battery clip (B) Fig.3 to remove battery from charger.
Installing/removing battery from impact driver
To install a battery (A) Fig.3 to the base of the cordless
impact driver, align the grooves the battery with those of
the impact base and slide the battery all the way until the
battery clip (B) snaps and holds the battery into place.
To remove the battery from the base, press the battery
clip (B) Fig.3 and slide the battery away from the base.
Variable speed trigger
Your cordless impact driver is equipped with a variable
speed trigger (A) Fig.4. The speed can be controled from
the minimum to the maximum RPM just by the pressure
applied to the trigger switch. Apply more pressure to
increase speed and apply less pressure to decrease
speed. Release trigger to stop impact driver.
Forward/reverse switch and trigger lock
Your cordless impact driver is equipped with a
forward/reverse switch and trigger lock (B) Fig.4. It is
located above the trigger. This switch is designed to
change the direction of rotation of the chuck and to lock
the trigger to help prevent accidental starts and battery
discharge. For a forward rotation (with the chuck pointing
away from you) move the lever to the left. For reverse
rotation move the lever to the right. To lock the trigger, place the lever in the centre
position.
WARNING! Do not change the rotation direction until the impact driver chuck has
come to a complete stop. Changing the rotation during an operation can cause
damage to the tool.
Electric brake
This impact driver is equipped with an electric brake. If the tool consistantly fails to stop
quickly after the trigger is released, have the tool serviced.
Figure 2
Figure 3
Figure 4
Advertisement
