Usb Configuration Utility - D-Link Air DWL-900AP User Manual

USB Configuration Utility

When the Wireless AP USB Configuration Utility and Wireless AP SNMP
(Simple Network Management Protocol) Utility have been installed you can
configure settings for the access point. Before you can use the SNMP Utility,
you must configure the device IP address. The IP address of the device must
be on the same subnet and use the same subnet mask as the computer
using the SNMP Utility.
Using the USB Configuration Utility
To use the USB Configuration Utility and change the IP settings of the
Access Point, follow these steps:
1. To launch the USB Configuration Utility, go to your Start menu, open
Programs, find the Wireless AP folder and open it. You will see two new
icons have been placed in this folder. Scroll to the Wireless AP USB
Utility and click on it to launch the program.
2. The Admin Password screen will ask you for a password. The default
password is "public" (all lower case), type this in the space and click OK.
3. The USB Configuration Utility management interface will appear
displaying system information about the Wireless Access Point.
access any of the menus listed just click on the tab. If you intend to use
the SNMP Utility to manage and configure the device you must first
change the IP settings.
4. Click the IP Config tab to change the IP settings of the device.
To