Kenmore 405.35182510 Use & Care Manual page 4

GUARD & FAN BLADE ASSEMBLY
1. Unscrew and remove the spinner clockwise (or remove
from parts bag) and the plastic nut counterclockwise.
Fig. 6. Mount the rear guard against the motor face
so that the pin at the motor face bottom fits through the
tear drop hole in the rear guard mounting ring. When
correctly mounted the set of two tabs on each side of the
motor face will also fit through their designated holes in
the mounting ring, and the rear guard will rest flat and
evenly on the motor face. Screw the plastic nut back onto the
motor face to secure the rear guard in place. Fig. 5.
2. Mount the Blade set onto the motor shaft through the center hole in the Blade set.
Insert the retaining pin on the motor shaft into the slots in the Blade set core. Insert
the spinner onto the tip of the shaft and turn spinner counterclockwise to secure
the Blade set in place. Fig. 7.
3. Open the five latch clips on the rear guard. Align the logo on the front guard so
that it will read horizontally. Insert the edge of the front guard into the fixed clip
at the bottom of the rear guard. Use the five latch clips to secure the two guards
together. Fig. 8
Fig.6
OPERATING INSTRUCTIONS
I. Remote Control (Fig.9)
" " ON/OFF KEY
Press this key to start fan. Fan will resume operation at previous
speed and mode setting. Press this key again to turn fan off.
" " TIMER KEY
Press this key to set a time period for the fan to run and then
automatically turn off. The time settings are 1, 2 and 4 hours.
An indicator light on the control panel shows which time has been selected. If no
selection has been made, the fan will run until turned off by the On/Off key.
" " SPEED KEY
Press this key to select Low, Medium or High fan speed. An indicator light on the
control panel shows which speed has been selected.
Fig.7
3
Fig. 5
Fig.8
Fig.9