Kenmore 405.35182510 Use & Care Manual page 3

PART FIGURE
1.Front guard
2.Spinner
3.Blade set
4.Plastic nut
5.Rear guard
6.Motor unit
7. Oscillation Control Button
8.Fan neck
9.Control panel
10. Height adjustment ring
11.Remote Control
ASSEMBLY OF BASE
1. Unscrew the Finger screw and washer from the bottom of the Extension pole.
Fig. 1
2. Insert the Extension pole into the Floor base. Insert the finger screw with washer
into the hole on the underside of the Floor base and into the Extension pole.
Securely tighten Finger screw. Fig. 2
3. Loosen the Height adjustment ring at the top of the extension pole. Raise the
internal metal pole to the desired height and securely tighten the Height
adjustment ring. Fig. 3
NOTE: If the internal pole is not visible it has slipped out of sight into the
extension pole. Loosen the Height adjustment ring to slide the internal pole out.
4. With a Phillips screwdriver loosen, but DO NOT REMOVE, the mounting screw in
the Fan neck base of the Motor unit. Insert the internal pole into the Fan neck
base as far as it will go. Tighten the screw to secure the motor unit in place. Fig. 4.
NOTE: If the screw is removed the retaining nut may slide out of its notch in the
motor unit base. If the nut slides out, insert it all the way into the notch, then insert
the screw into the mounting hole and tighten.
CAUTION: The Height adjustment ring must be tightly fastened before mounting
the motor unit to the internal pole.
Fig.1
12.Remote Control Holder
13. Floor Base
14. Finger Screw
Fig.2
1 3
2
Fig.3
2
4 5 6 7
11
12
13
14
Fig.4
Mounting hole
13
14
8
9
10