Operation - D-Link DW-655C User Manual

Install Configuration Utility
1. Restart the computer and ensure D-Link Wireless LAN Configuration Utility CD in the
CD-ROM drive.
You can run the program manually by selecting Run from the Start menu and running
SETUP.EXE from the CD-ROM drive.
D:\DW655C\SETUP.EXE (if D:\ is your CD-ROM drive)
2. On the D-Link DW-655C Wireless LAN PC Card – Installation screen, click next to start
software installation. Read the information in the Welcome dialog box and click "Next".
Then, click "Yes" if you accept the Software License Agreement.
3. Enter the name of the Wireless LAN Service Set of the wireless network (SSID) to
which your computer will connect. The name you enter here must match exactly the
name assigned to the access point. Characters, capitalization, and spacing must be
identical.
NOTE: If the access point you wish to associate with has encryption active, you must
also enable encryption on the wireless client. Click Encryption in the Configuration
Utilities after reboot to go to screens where you can enable and configure encryption.
You must set the wireless client for the same Encryption algorithm and Key values as
the access point it will associate. Refer to the Advanced Configuration section for more
details about configuring encryption
4. Select which network mode is suitable for your Wireless LAN. Infrastructure Mode is
default selection. This setting can be changed at any time after installation completion.
5. Accept the default program folder or select where the SETUP.exe stores the
Configuration Utility.
6. Select ""Yes", I want to restart my computer now". Reboot your computer by clicking
Finish.

Operation

Orienting the Antenna
The PC Card antenna is attached to the end of the PC Card. For best use of the antenna:
Keep the area around the antenna clear from materials that could block or obstruct
- 4 -