Placement; Supply Line; Maintenance; Cartridge Replacement - Westinghouse QL0232 Owner's Manual

Installation (continued)

PLACEMENT

Move the assembled unit to its final location. If required, level the unit by adjusting the cabinet feet (K). Ensure that no rocking is
exhibited .

SUPPLY LINE

The supply lines, which connect the faucet to the household water system, are
not supplied with this unit . They need to be purchased separately . Follow the
supply line manufacturer's instructions for proper installation .

Maintenance

CARTRIDGE REPLACEMENT

If in the future the ceramic cartridge needs to be replaced:
1 . Turn off the water supply to the faucet (C) .
2 . Take off the plastic water temperature sign by hand, then use the
Hex key to take out the screw and pull out the handle body . The top
lever of the cartridge will be exposed .
3 . Unscrew the cap and rings, making sure not to damage the
threads .
4 . Pull the cartridge out of the faucet body and replace it with a new
35 mm ceramic cartridge .
5 . Replace the rings, then the cap .
6 . Place the handle body on the cartridge . Lock the screw back onto
the handle body and tighten it with the Hex key . Do not over tighten .
7 . Put the plastic water temperature sign back into the hole, make
sure that red is on the left and blue is on the right .
8 . Slowly open the water feed to the faucet to test .
Cartridge
Faucet body
10
Water temperature sign
Screw
Cap
Rings
Handle
body