Installing The Faucet; Installing The Strainer; Placement - Westinghouse 180229 Owner's Manual

Installation (continued)

INSTALLING THE FAUCET

- Install the mounting studs into the faucet properly .
Attach the gasket to the base plate, and put base plate to fit
-
the underside of faucet .
- Install and tighten the Hot and Cold water hoses to the faucet
using a wrench . Do not overtighten .
- Insert the water hoses and mounting studs through the faucet
hole in the sink, from the top .
- Install the rubber gasket, metal washer, and retaining nuts onto
the mounting studs to secure the faucet to the sink . Tighten
the retaining nuts to the sink using a wrench until they are
snug . Do not overtighten .
- Attach and hand tighten the supply lines (not supplied) onto the
hot and cold water hoses . Use two wrenches to tighten the two
ends together. Please note, tightening the fittings with a single
wrench may damage the faucet and void the warranty .
NOTE:
It is helpful to have a second person hold the faucet in place while
tightening the mounting nuts. Please ensure that none of the supply lines
are kinked during installation.

INSTALLING THE STRAINER

NOTE:
The drain assembly is not included with this product. Please
purchase an appropriate drain assembly and follow the
manufacturer's instructions to install it.
PLACEMENT (BEFORE MOUNTING THE SINK)
- Place the cabinet in the intended location and push it
against the wall . If required, level the cabinet by adjusting
the four leveling legs and checking the alignment of the
sink using a carpenter's level .
- Draw the location of the mounting anchors on the wall and
install the anchors into the wall . If a gap exists between
the top of the cabinet and the wall, insert spacers or shims
between mounting brace and the wall . Secure the cabinet
to the wall using anchor screws (H) .
Test fit the sink to make sure it fits correctly and make
-
adjustments as needed before proceeding .
QVA085
SINK
Hot Water Hose
Cold Water Hose
J
Shims
H
8
Handle
Faucet
Base Plate
Gasket
Mounting Studs
Rubber Gasket
Metal Washer
Retaining Nut
Mounting Brace