D-Link DP-101P+ Quick Installation Manual page 2

Connecting The DP-101P+ To Your
Network
First, insert one end of a CAT5 Ethernet RJ-45 cable into
the "Network Port" (shown below.) Connect the other
end of the cable to the LAN port of the gateway or
Note: Do not connect the power cord to the DP-101P+ until
you are advised to do so
Next, make sure that the Printer is turned OFF.
Connect the DP-101P+ to the parallel port of the printer.
Using the printer cable, connect one end of the cable to the
printer port of the DP-101P+ (shown below) and the other
end to the parallel port of the printer.
Turn ON the printer.
Then, plug one end of the power adapter into the DP-101P+
(in the DC Power Input port, shown in the illustration on the
previous page) and the other end into your electric outlet.
The DP-101P+ will turn on and begin a self-test.
switch.