JVC KD-X360BTS Instruction Manual page 22

BLUETOOTH®
[SETTINGS]
[AUTO ANSWER] [01 SEC] to [30 SEC]: Answers an incoming call automatically in the selected
time (in seconds). ; [OFF]: Cancels.
[RING COLOR] KD-X360BTS:
[COLOR 01] to [COLOR 49] ([COLOR 08]): Selects the illumination color for
the buttons as notification when there is an incoming call and during a call. ;
[OFF]: Cancels.
[RING ILLUMI] KD-X260BT/1/KD-SX25BT:
[BLINK 01] to [BLINK 05] ([BLINK 02]): Selects the blinking pattern for the
buttons as notification when there is an incoming call. ; [OFF]: Cancels.
Make a call
You can make a call from the call history, phonebook, or dialing the number.
Call by voice is also possible if your mobile phone has the feature.
1 Press to enter Bluetooth mode.
"(First device name)" appears.
• If two Bluetooth phones are connected, press
the other phone.
"(Second device name)" appears.
2 Turn the volume knob to select an item (see the following table), then
press the knob.
3
Repeat step 2 until the desired item is selected/activated or follow the
instructions stated on the selected item.
To return to the previous setting item, press
18
ENGLISH
JS_JVC_KD_X360BTS_K_EN_4.indd 18
Default: [XX]
[RECENT CALL]
[PHONEBOOK]
[DIAL NUMBER] 1 Turn the volume knob to select a number (0 to 9) or character
again to switch to
[VOICE]
1
2
.
• Supported Voice Recognition features vary for each phone. Refer to the
(Applicable only if the phone supports PBAP.)
1 Press the volume knob to select a name or a phone number.
• "<" indicates call received, ">" indicates call made, "M" indicates call
missed.
• "NO HISTORY" appears if there is no recorded call history or call number.
2 Press the volume knob to call.
(Applicable only if the phone supports PBAP.)
1 Press 2 J / 1 K to select the desired letter (A to Z, 0 to 9, and OTHERS).
• "OTHERS" appears if the first character is other than A to Z, 0 to 9.
2 Turn the volume knob to select a name, then press the knob.
3 Turn the volume knob to select a phone number, then press the knob to
call.
• The phonebook of the connected phone is automatically transferred to the
unit when pairing.
• This unit can display only non-accent letters. (Accent letters such as "Ú" are
showns as "U".)
( , #, +).
2 Press S / T to move the entry position.
Repeat steps 1 and 2 until you finish entering the phone number.
3 Press the volume knob to call.
Speak the name of the contact you want to call or the voice command to
control the phone functions. (See "Make a call using voice recognition".)
Make a call using voice recognition
Press and hold to activate the connected phone.
Speak the name of the contact you want to call or the voice command
to control the phone functions.
instruction manual of the connected phone for details.
6/1/2018 3:52:18 PM