Raid Configuration (Optional); Configuration Sata Mode - MSI B360M BAZOOKA User Manual

RAID Configuration (optional)

Below are the different types of a RAID.
RAID 0 breaks the data into blocks which are written to separate hard drives.
Spreading the hard drive I/O load across independent channels greatly
improves I/O performance.
RAID 1 provides data redundancy by mirroring data between the hard drives and
provides enhanced read performance.
RAID 5 provides data striping at the byte level and also stripe error correction
information. This results in excellent performance and good fault tolerance.
RAID 10 uses four hard drives to create a combination of RAID 0 and 1 by forming a
RAID 0 array from two RAID 1 arrays.
RAID level comparison
Minimum # drives
Data protection
Read performance
Write performance
Capacity utilization

Configuration SATA mode

First, you need to go to BIOS > SETTING > Advanced > Integrated Peripherals and set
the SATA mode to RAID/ Optane Mode to create, delete and reset RAID volumes.
Important
The following procedure is only available with a newly-built system or if you are
reinstalling your OS. It should not be used to migrate an existing system to RAID.
RAID 0 RAID 1
2 2
None Excellent
Excellent OK
Excellent Good
100% 50%
RAID 5 RAID 10
3 4
Excellent Excellent
Good OK
OK Good
67%~(1-1/n) 50%
RAID Configuration (optional)
87