NETGEAR EX6400 Quick Start Manual page 12

¾ To use the extender in access point mode:
1. Set the Access Point/Extender switch to Access Point
2. Plug the extender into an electrical outlet.
The Power LED lights green.
If the Power LED does not light, press the Power button.
3. Connect a computer or mobile device to the extender using a WiFi or
Ethernet connection:
• WiFi. On your WiFi-enabled computer or mobile device, open the
WiFi connection manager and locate and connect to the extender
network called NETGEAR_EXT.
When your WiFi-enabled computer or mobile device is connected
to the extender, the Client LED
• Ethernet. Use an Ethernet cable to connect the Ethernet port on
the extender to an Ethernet port on your computer.
Note:
this before you connect your extender to your modem router or
router.
4. Launch a web browser and visit www.mywifiext.net.
The NETGEAR installation assistant displays.
If you want to use an Ethernet connection, you must do
lights.
12
.