Additional Features; Serial Port Configuration; Encoder Status Commands - EEG HD1490 Product Manual

4 Additional Features

4.1 Serial Port Configuration
Change Baud Rate:
the baud rate on P2, the AUX RS-232 input port. A change in communi-
cation settings takes effect immediately; thus, after entering this com-
mand, you must immediately begin communicating at the new settings
you entered.
Baud Sets the new baud rate for the port. Supported rates
are 1200, 2400, 4800, and 9600.
Bits Sets the number of data bits. Choose either 7 or 8.
Parity Sets the parity bit. Choose either o for odd, e for even,
or n for none.

4.2 Encoder Status Commands

Report Identification:
Returns the Encoder's model, serial number, and firmware version.
Report HD Status:
Returns the Encoder's current HD operation setting (334M VANC Inser-
tion, 333M VANC Recovery, or GA VANC Recovery) and the availability
of an HD video source (HD–SDI Present or HD–SDI Not Present). If an
HD signal is present, the video format of the source and whether or not
VANC caption data is present are also reported.
Recovery Status:
<CTRL+A>A <ENTER>
Returns the data recovery status of each Line 21 channel for incoming
SD video. ON indicates that data on the channel is being recovered
and processed. OFF indicates that the channel has been turned off and
incoming data is being ignored.
SD Video Presence:
Reports either Video Present or No Video Present to indicate whether or
HD1490 HD Encoder Frame Card
<CTRL+A>I P2 Baud Bits Parity <ENTER>
<CTRL+A>? <ENTER>
<CTRL+A>f <ENTER>
<CTRL+A>b <ENTER>
Changes
27