EEG HD1490 Product Manual page 24

Load XDS Packet:
<ENTER>
Creates an XDS packet and loads it into the XDS queue. The Encoder
will begin inserting the packet immediately.
Packet Packet sets the XDS Class and Type of the packet that
will be created. If a new packet is loaded with the
same Packet ID as an existing packet in the queue,
the pre-existing packet will be deleted; if the new
packet is a Program Name or Program ID packet,
all program-specific packets will be deleted from
the queue.
the Load XDS Packet command has local priority; in
output signals, it will replace all upstream packets
of the same Class and Type. The Packet parameter
should be entered as Class immediately followed by
Type in the way shown in the table below. Leading
zeroes may be omitted. The Class and Type of a few
of the most commonly used XDS packets are shown
in the following table; for a complete list refer to
CEA-608B.
Class/Type
0102
0103
0105
0501
0502
0504
HD1490 HD Encoder Frame Card
<CTRL+A>P Packet Duration Content [Priority]
A packet loaded into the Encoder with
Content
Current Program Length
Current Program Name
Current Program Rating
Network Name
Station ID (Call Letters)
TSID
23