Start And Programmes - Hotpoint TVFS 83 Instruction Booklet

Start and Programmes

Choosing a programme
GB
1. Plug the dryer into the electrical socket.
2. Sort your laundry according to fabric type (see Laundry).
3. Open the door and make sure the filter is clean and in
place (see Maintenance).
4. Load the machine and make sure items are not in the
way of the door seal. Close the door.
5. If none of the lights are on: Press the ON/OFF button
6. Choose a programme, or Timed Drying, by checking
the Programmes Guide (see Programmes) as well as the
indications for each type of fabric (see Laundry).
- Select a programme by rotating the PROGRAMMES
knob.
7. Choose Timed Drying or Dryness Levels option.
8. Set a delay time and other options if necessary.
9. The START/PAUSE light is flashing green:
- press the START/PAUSE
light stops flashing.
During the drying programme, you can check on your
laundry and take out items that are dry while others
continue drying. When you close the door again, press the
Note: This tumble dryer, in compliance with new energy saving regulations, is fitted with an automatic standby system
which is enabled after about 30 minutes if no activity is detected. Press and hold the ON/OFF button until the dryer
reactivates.
Description of program
Programme
n°
Max. load
Notes/ Options available
Ready to
Wear
1
max Delay Timer - Crease Care
Standard
Cotton
2
max Fibre Care - Delay Timer - Crease Care
Easy Iron
3
max Fibre Care - Delay Timer - Crease Care
Synthetics
4
4 kg Delay Timer - Crease Care
•
Synthetics
Easy Iron
5
Delay Timer - Crease Care
4 kg
•
•
Silk
6
0.5 kg -
8
button to begin. The green
• This is a programme for cotton items.
• Dries your items ready for using, drier than programme Standard Cotton.
• This is a programme for cotton items.
• Clothes dried using this programme are usually ready to put away.
• The Standard Cotton programme to EU Regulation 392/2012 is Programme 1 selection with High Heat
and Dryness Level Cupboard Dry (the standard/default configuration). This is the most efficient programme
in terms of energy consumption (EU 392/2012).
• This is a programme for cotton items.
• Dries your items to a dryness level that allows them to minimise ironing.
• Recommended to delicately dry synthetic fabrics.
• Clothes dried using this programme are usually ready for putting away.
This is a programme for items of Synthetic or Synthetic/Cotton mixtures, with a level of dryness that
minimizes ironing.
This is a programme for drying your delicate silk.
Loads dried using this programme are usually ready to use, but on some heavier garments the edges may
be slightly damp. If this is the case, remove the load and open them out and then run the programme again
for a short period.
START/PAUSE button in order to resume drying.
(When the door is opened the START/PAUSE light will flash
Amber, after the door is closed and the START/PAUSE
button pressed, the START/PAUSE light will stop flashing
and show green.)
Note: During the Post Care phase this light flashes Amber.
10. At the end of the drying cycle the End light comes on and
.
either :
- The buzzer will beep 3 times to let you know that your
programme is complete.
or- If you have selected the Crease Care option and
you do not take the items out immediately, the items will
tumble occasionally for 10 hours or until you open the
door, the buzzer will then beep 3 times to confirm the
programme is completed.
11. Open the door, take the laundry out, clean the filter and
replace it.
12. Unplug the dryer.
Cycle
duration*
140'
130'
125'
60'
40'
30'