Philips HTS3274/51 Service Manual page 12

DISASSEMBLY INSTRUCTIONS
Dismantling of the Front Panel Assemble
) Open the DVD Tray by using the Open/Close Button while the Set is ON and disconnect the mains supply after removing the Tray
Cover.
Note: If this is not possible, the DVD Tray has to be open manually.
Take a mini screw driver about 2mm diameter and make a marking 24mm from the tip as shown in figure 2 . Place the set on its
side, insert the mini screw driver till the marking and slide it towards the left as shown in figure  until the Tray moves out of the Front
Panel.
2) Return the set to its upright position and remove the Tray Cover as shown in Figure 3 and close the tray manually by pushing it back
in.
24mm
3 - 
Figure 
Figure 2
Figure 3
3) Loosen 6 screws and remove the Top Cover by lifting the rear portion upwards before sliding it out towards the rear.
-  screw "A" each on the left & right side as shown in figure 4.
- 4 screws "B" at the back panel as shown in figure 5.
4) Loosen 5 screws "C" at the front panel bracket as in figure 6 to remove the front panel.
C
Dismantling of the DVD Module
) Loosen 4 screws " D " at the DVD Module as shown in figure 7.
D
3 - 
A
Figure 4
Figure 5
Figure 6
Figure 7