Page 1
SLE 3219 LED Television operation. Keep it for future use. Record the model number and the serial number of the television. See the label on the rear cover and provide this information to your vendor in the event that you...
Important safety measures If you want to use this product correctly, carefully read this user's manual and store it for future reference. If you give (sell) the appliance to somebody, please also include all the documentation together with this appliance, including this user's manual. The ash symbol in an equilateral triangle indicates that there is dangerous voltage inside this appliance, which presents a risk of injury by electrical shock.
Page 4
Important safety measures • The appliance must not be exposed to dripping or running water and objects lled with water must not be placed on it, e.g. vases. Protect the appliance against rain, spray or contact with any other liquid, do not leave or install the appliance outdoors. Do not use the appliance outdoors. Not adhering to these instructions creates a risk of electrical shock or re hazard.
Page 5
Important safety measures Note: If the appliance is powered by an adapter, use only the adapter and AC power cord supplied with the appliance. Do not use faulty power sockets. Check that the power plug is properly inserted into the power socket.
Page 6
Important safety measures • The incorrect use of batteries may cause the leakage of the electrolyte and corrosion. To ensure that the remote control works correctly, proceed according to the instructions below: Do not insert the batteries in the wrong polarity orientation. Do not charge, heat, open or short circuit the batteries.
Page 7
Important safety measures Notes on the USB connector: USB memory devices must be inserted into the appliance directly. To prevent data transmission failure or its interference, do not use USB extension cables. Electrostatic discharges may cause the appliance to malfunction. In such an event the user must restart the appliance. Before using a USB ash drive test its ability to communicate with the appliance and its data reading and writing speed.
Description of the appliance 1. Description of the appliance 1.STANDBY button 2.SOURCE button 3.MENU button 4.CH +/- button 5.VOL +/- button 6.IR remote control sensor Power indicator INPUT STANDBY button Turns the television on from the stand-by mode. VOL +/- button Press to increase/decrease the volume.
Remote control 2. Remote control 1. STANDBY button Turns the television on from the stand-by mode. 2. SOURCE button Press to select the desired input. 3. Numerical buttons 0-9 Press 0-9 to directly select a TV channel while watching the TV. In teletext mode enter the page number, etc.
Page 10
Remote control 20. REC button Note: Used to start recording (only in DTV mode). Remove the batteries if you will be storing the appliance or not using it for an extended period 21. AUDIO button of time. DTV/MEDIA mode: select a background sound, if •...
Connecting and setting up Connecting and setting up Video (yellow AV) Audio right (red AV) W Audio left (white AV) Component Y (green) Component Pb (blue) Component Pr (red)
Page 12
Connecting and setting up Installing cables Please carefully read the entire user's manual before installation and operation. 1. Take the TV out of the packaging and place it on an even rigid surface. Note: Before connecting or disconnecting a TV, computer or other devices it is necessary to check that the power cord is disconnected.
Troubleshooting guide 8. Troubleshooting guide Troubleshooting Before contacting the service centre, please perform the following simple checks. If problems persist, disconnect the TV and contact a service centre. PROBLEM POSSIBLE SOLUTION No picture and sound - Check that the power cord is connected to the wall power socket. - Check that you have not pressed the POWER button on the front panel of the TV receiver.
Page 33
Troubleshooting guide Note: Problem in the VGA mode (only for the VGA mode). PROBLEM POSSIBLE SOLUTION The signal is out of range. - Set the resolution, horizontal frequency or vertical frequency. - Check whether a signal cable has not come loose. - Check the input source.
SLE 3219 ( " 81cm) e l i ≤ l l a 200 x 100 mm 730 x 470 x234mm 730 x 430 x77mm 817 x 515 x133mm Connection l a i , I V MP3, AAC, WAV, JPG, JPEG, TXT...
Information sheet 10. Information sheet Manufacturer: FAST ČR, a.s., Černokostelecká 1621, 251 01 Říčany, Česká republika Brand Sencor SLE 3219 ] " / 81cm/32” ≤ ] s l 1366 x 768 * Power consumption of 44 kWh per year, based on the power consumption of a television, operating...
Page 36
INSTRUCTIONS AND INFORMATION REGARDING THE DISPOSAL OF USED PACKAGING MATERIALS Dispose of packaging material at a public waste disposal site. DISPOSAL OF USED ELECTRICAL AND ELECTRONIC APPLIANCES The meaning of the symbol on the product, its accessory or packaging indicates that this product shall not be treated as household waste.
Need help?
Do you have a question about the SLE 3219 and is the answer not in the manual?
Questions and answers