Download Print this page
Camp Chef PRO 30 Important Instructions On Assembly And Safety

Camp Chef PRO 30 Important Instructions On Assembly And Safety

Max pot diameter 8”

Advertisement

Quick Links

WARNING: Read Thoroughly
Before Use
DO NOT DISCARD THESE SAFETY INSTRUCTIONS
IF YOU SMELL GAS
1. Disconnect gas to the appliance.
2. Extinguish any open flame.
3. If odor continues, immediately leave the
premises and call your gas supplier or local
fire department.
FOR OUTDOOR USE ONLY
If stored indoors, detach hoses and leave
fuel cylinder outdoors, with valve closed and
plugged.
FUEL TYPE
This unit is designed for use with propane only.
No other fuel is approved for use with this unit.
FUEL CYLINDER
Always store fuel bottles in a safe outdoor
area with valve closed and plugged. Follow the
manufacturer's recommendation for proper use
and storage of propane cylinders. Do Not Place
Propane Cylinders Directly Under Any Part of
the Burners.
CAUTION
Place the tank so as to minimize the possibility
of someone tripping over the connection hoses
while the cooker is set up. Never Lean Over or
Stand too Near the Cooker, or Allow Children or
Pets Near the Cooker During Use.
COMBUSTIBLE MATERIALS
During operation of cooker, insure proper
clearance from any combustible materials, in
relation to the top, sides and back of cooking
appliance. For outside use only. Do not use near
flammable walls or under eaves or overhangs
of homes or garages. Never leave unattended
while hot or in use. Allow cooker to cool before
take down and storage. The propane tank must
always be stored outdoors in a well ventilated
space. Never Stand or Lean Over Cooker Burner
While Lighting.
FOR YOUR SAFETY
Follow all safety, set-up, lighting and cooking
instructions. Do not store or use gasoline or
other flammable vapors and liquids in the
vicinity of this or any other appliance.
IMPORTANT INSTRUCTIONS ON ASSEMBLY AND SAFETY FOR YOUR CAMP CHEF COOKER
PRO 30
Model: SB30D
• One Universal Output (30,000 BTU/hr)
Cast Burners
• Systéme puissant á 1 brûleur de sortie universelle
• Detachable Legs
• Pattes amovibles
• Convenient 31" Cooking Height
• Hauteur du plan de travail de 78,7 cm (31 po)
• Appliance-style Temperature Controls
• Appareils de type Commandes de température
• Cloverleaf Cooking Surface
• Surface de cuisson Cloverleaf
ANSI Z21.89b-2012 CSA 1.18b-2012
S T E P 1
Screw out thumb screws until flush with inside of
cooker leg. Apply extension to each leg. Hand tighten
thumb screws.
Stand cooker upright on solid level ground. To level:
loosen thumb screw on leg extension and adjust leg
height. Hand tighten thumb screw.
Do Not use stove without leg extensions.
S T E P 2
Use an adjustable or 3/4" wrench to connect flare
fitting to stove fitting. Tighten securely with wrench.
DO NOT OVER-TIGHTEN.
Before attaching regulator to tank, ensure that all
valves are in the OFF position.
S T E P 3
Attach regulator to tank. Check all connections to
ensure tightness. With all valves in the off position,
apply a soapy water solution to all fittings, valves and
connections. Turn gas on at the tank and check for
leaks at all connections. Small bubbles will appear if
connection leaks. Tighten as needed.
S T E P 4
Turn on tank. Place a lit long nose lighter into round
lighting hole on cooker front. Turn valve knob to LOW.
Burner should light. If ignition does not occur in 5
seconds, turn the burner controls off, wait 5 minutes,
and repeat the lighting process.
R E G U L A T O R
New Type 1 Connection: Right hand turn to connect
securely to New Type 1 tank.
T R O U B L E S H O O T I N G
PROBLEM WITH FLAME?
(Flame should burn blue with a hint of yellow.)
Yellow Flame: Adjust air shutter open until burner
shows blue flame.
Still Yellow: Shut off valve(s) at stove and fuel tank.
Through air shutter opening, clean venturi (burner
neck) of obstructions such as cobwebs, dirt or bugs.
•Open Tank Valve Slowly
venturi
Small Flame: Flame will not adjust any larger... (Safety
Low Pressure
Feature: New Low Pressure Regulator will detect a
Burner
sudden use of gas and automatically go into a "low
Quemador De
Baja Presión
flow" mode and needs to be reset) Turn off all valves
Faible Pression
at stove and at tank. Assure all fittings are tight and in
Au Bruleur
good repair. Test for leaks. Repeat steps 2, 3 and 4.
•Open Tank Valve Slowly
WARNING: Chemicals known to the state of California to cause cancer, birth defects, or other reproductive harm are created by the combustion of propane.
Sport Utility, Big gASS Grill, Keg Roaster, Ultimate Roaster Are From the Makers of Camp Chef and Covered Under One or More of the Following Patents:
MAX POT DIAMETER 8"
Regulator Model#
R329, RA329, RJ-A
Tank Sold Separately
150/451
JY70-003
JY95A7A
RYQF01
KEEP FOR FUTURE REFERENCE
356714, 378646, 417120, 328547, 358057, 364772

Advertisement

loading

Summary of Contents for Camp Chef PRO 30

  • Page 1 WARNING: Chemicals known to the state of California to cause cancer, birth defects, or other reproductive harm are created by the combustion of propane. vicinity of this or any other appliance. Sport Utility, Big gASS Grill, Keg Roaster, Ultimate Roaster Are From the Makers of Camp Chef and Covered Under One or More of the Following Patents: 356714, 378646, 417120, 328547, 358057, 364772...
  • Page 2 Warranty does not cover normal wear of parts or damage caused by misuse, abuse, verheating and alteration. Repairs or alterations made by #8 SHELF SCREW (1) anyone other than Camp Chef are not covered 330028 in this Warranty. Manufacturer will not be held MANIFOLD (1) liable for any losses due to neglectful operation.
  • Page 3 How to Convert a Fire Pit, Stove , & Smoker to Natural Gas...
  • Page 4 NGKIT, which is our Natural Gas Conversion Kit, is needed to convert any Low Pressure Stove, Smoke Vault, or Fire Pit.
  • Page 5 Fire Pit Conversion to Natural Gas Remove valve from Safety first! Make sure burner, unscrew from everything is shut off and thermocouple wire, and that hose is removed disconnect electrode from propane tank. wire. Remove knob and valve cover. Once valve is removed from fire pit, drill the orifice with a 1/8th drill bit.
  • Page 6 Stove Conversion to Natural Gas Start by making sure all is shut off and that hose is removed from propane tank. Remove knobs and front panel. At this point all you need to do is remove NOTE: Only low pressure stoves the manifold from (30,000BTU or the valves..
  • Page 7 Smoke Vault Conversion to Natural Gas To convert the Smoke Vault to natural gas you’ll need the NGKIT and a #51 drill bit. If you haven’t assembled your smoker yet, remove the valve from the burner and use the specified drill to widen the valve’s orifice.
  • Page 8 If your smoker is already assembled and has been used, make sure everything is turned off and disconnect the hose from your smoker. Then lay the smoker on it’s back and remove the burner. This will give you access to the valve. Drill valve’s orifice with a #51 drill bit.

This manual is also suitable for:

Sb30d