Operation - Makita JR3000V Instruction Manual

ASSEMBLY
2
1
1. Screw
2. Hex wrench
2
3
5
1. Slider
2. Pin
3. Blade clamp
4. Screw
5. Blade
6. Hole

OPERATION

6
CAUTION:
• Always be sure that the tool is switched off and unplugged before
carrying out any work on the tool.
Installing or removing saw blade
002503
CAUTION:
• Always clean out all chips or foreign matter adhering to the blade, blade
clamp and/or slider. Failure to do so may cause insufficient tightening of
the blade, resulting in a serious injury.
To install the blade, loosen the screw on the blade clamp with the hex wrench.
Insert the blade between the blade clamp and the slider so that the pin on the
slider fits into the hole in the blade shank. If the pin cannot easily fit into the
hole, remove the hex wrench from the screw and then try again.
After the pin fits properly into the hole, tighten the screw clockwise securely
while making sure that the blade cannot be extracted even though you try to
pull it out.
002509
1
CAUTION:
• If you tighten the screw without the pin on the slider fitting properly in the
hole in the blade shank, the pin or the blade shank will be damaged. This
4
may cause the blade to be extracted unexpectedly during operation.
To remove the blade, follow the installation procedure in reverse.
6
CAUTION:
• Always press the shoe firmly against the workpiece during operation. If
the shoe is held away from the workpiece during operation, strong
vibration and/or twisting will be produced, causing the blade to snap
dangerously.
• Always wear gloves to protect your hands from hot flying chips when
cutting metal.
• Be sure to always wear suitable eye protection which conforms with
current national standards.
• Always use a suitable coolant (cutting oil) when cutting metal. Failure to
do so will cause premature blade wear.