Belkin Baby 200 User Manual page 12

sEtting Up
Baby unit
Plug the remaining power adapter cable into the
socket marked on the back of the Baby unit and plug
the other end into the mains power and switch on.
Warning
Never use non-rechargeable batteries in the Parent unit.
Only use the recommended type – 2 x AA NiMH 1300mAh
batteries. Using other types could permanently damage the
unit. Charge the batteries as instructed in this user guide.
The Parent unit can still be used when it is in the charger.
Removing the batteries
If you ever need to remove the batteries, simply slide open the battery
compartment cover and use the ribbon to eject the batteries.
switch on and link the Parent and Baby units
1. Press and hold the
for 1 second. The nightlight will briefly illuminate
and then the green Link indicator will flash.
2. Press and hold the
on the unit briefly illuminate. The green Link indicator will flash.
Once the units are linked, the green Link indicators on
the Parent and Baby units will stop flashing and remain
a steady green. The units are now ready to use.
Important:
The link confirmation between the two units is vital for use so
they can communicate. If the link between the units is broken
at any time, the Link indicators on the Parent and Baby units
will flash green as they try to search for each other. After
30 seconds, if the link is still broken they will flash red and
you will also hear an alert signal from the Parent unit.
26
button on the Baby unit
button on the Parent unit until all the LEDs