Table of Contents
Advertisement
Available languages
Available languages
ASSEMBLING THE COMPRESSOR
1.
Unpack the air compressor. Inspect the unit for damage. If the unit has been
damaged in transit, contact the carrier and complete a damage claim.
Do this immediately because there are time limitations to damage claims.
2.
Check the compressor's serial label to ensure that you have received the model
ordered, and that it has the required pressure rating for its intended use.
3.
Locate the compressor according to the following guidelines:
a.
Position the compressor near a grounded electrical outlet.
b.
The compressor must be at least 12 inches (31 cm) from any wall or
obstruction, in a clean, well-ventilated area, to ensure sufficient air flow and
cooling.
c.
In cold climates, store portable compressors in a heated building when
not in use. This will reduce problems with motor starting and freezing of
water condensation.
d.
Remove the compressor from the carton and place it on the floor or a hard,
level surface. The compressor must be level to ensure proper drainage of
the moisture in the tank.
4.
Assembling the wheels:
a.
Mount each wheel (D) with one 10mm nut (G), One 10 mm flat washer (F) ,
one wheel spacer (H), and one 10 mm shoulder bolt (E). Secure wheel (D)
in position by tightening nut (G) onto shoulder bolt (E) firmly using 17mm &
19mm wrenches.
D
E
ASSEMBLY
Figure 2
G
F
H
11 - ENG
(Figure 2)
Advertisement
Table of Contents
