Husqvarna V554 Operator's Manual page 13

CONTROLS
Fuel Gauge
Fuel gauge for the fuel tank is located on the
control panel. Sensors will indicate fuel levels.
The meter will flash yellow when the tank levels
approximately one gallon (3.8 liters).
Service Meter
The service meter is located on the left hand
control panel and shows the total operating time
with the blades engaged.
After every 50 hours of operation, an oil can icon
will appear and stay on for two hours, before
an automatic reset occurs. To manually reset
the meter, turn the key off and on five times at
one second intervals. To service the engine and
mower, see the Service Journal of this manual.
Fuses
The fuse box is located behind the operator
cushion. The fuses are the same type used in
automobiles. Check the decal for amps and
purposes.
Speed Control Bar
Located in front of the steering controls, the
speed control bar is used to change ground
speeds. Move the steering controls closer to (for
faster speed) or away from (for slower speed) the
speed control bar.
Deck Lift Lever
To set the deck cutting height, press the button
on the top of the height pin to remove it. Slip the
height pin into the hole for the desired cutting
height.
The cutting height can be set from 1-1/2"- 5"
(38 mm - 127 mm).
13