Table of Contents
Advertisement
Fault message at the end of a programme
Problem
Check filter + jet
The messages will appear at the end of the programme and when the washing
machine is switched on and need to be confirmed with the OK sensor.
Cause and remedy
The pumps are dirty.
Clean the pumps as described in "Problem solving
guide . .", Opening the door in the event of a
blocked drain outlet and/or power cut".
Restart the programme after cleaning.
The jet in the top of the door ring is blocked with fluff.
Remove the fluff with your finger. Do not use any
sharp or pointed tools to do this.
Restart the programme after cleaning.
If the fault message appears again, contact Miele.
The washing machine can still be used but with re-
duced functionality.
Problem solving guide
63
Advertisement
Table of Contents
