Advertisement
ELECTRICAL CONNECTIONS
A
Typical connections
Before connecting: Check the wiring in the vehicle carefully. Incorrect connection may cause serious damage to this unit.
The leads of the power cord and those of the connector from the car body may be different in color.
1
Connect the colored leads of the power cord in the order specified in the illustration below.
2
Connect the antenna cord.
3
Finally connect the wiring harness to the unit.
VIDEO OUT (see diagram
Antenna terminal
DIGITAL OUT
(see diagram
Line out (see diagram
White with black stripe
White
Left speaker (front)
B
Connecting the parking brake wire
When installing the monitor in a location where it can be seen by the driver
Connect the parking brake wire to the parking brake system built in the car.
Parking brake
When installing the monitor in a location where it cannot be seen by the driver
Connect the parking brake wire to metallic body or chassis of the car.
C
Connecting the crimp connector
Wire connecting the battery and the parking brake switch.
Attach the parking brake wire to this point.
*
1
Not supplied for this unit.
*
2
Before checking the operation of this unit prior to installation, this lead must be connected, otherwise power cannot be turned on.
)
15 A fuse
Rear ground terminal
To external components (see diagram
)
Black
*
2
Yellow
)
Red
Blue
Blue with white stripe
Light green
Gray with black stripe
Gray
Right speaker (front)
Parking brake switch (inside the car)
)
To metallic body or chassis of the car
To a live terminal in the fuse block connecting to the car battery
(bypassing the ignition switch) (constant 12 V)
To an accessory terminal in the fuse block
To the automatic antenna if any (250 mA max.)
To the remote lead of other equipment (200 mA max.)
Green with black stripe
Green
Left speaker (rear)
Contact the metallic part of the crimp to the wires inside.
3
Ignition switch
Fuse block
To parking brake, metallic body or chassis of the car
Purple with black stripe
Purple
Right speaker (rear)
Parking brake wire (light green)
To metallic body or chassis of the car
Parking brake wire (light green)
Pinch the crimp firmly.
Advertisement
