Analog Audio; Factory Use Only; Digital Audio - Sanyo CRD-BPDV2 Owner's Manual

Page 8
Document No.
(2/2)
(4) Names and Functions of Each Part on the Rear Panel
Rear Panel
5

1. ANALOG AUDIO

Connector
2. CS/SL/MA Pins
3. IDE Connector
4. DC Connector

5. FACTORY USE ONLY

Pins

6. DIGITAL AUDIO

Connector
7. UDMA Pins
Document Name
Dimensions, External View and Names and
Functions of Each Part
6
7
1
: The audio analog signal output connector.
: By covering the jumper block, these pins are used to set the CD-R drive to
either a Master or Slave mode to work with the hard disk drive inside the
personal computer.
Default is Master.
: Using a 40-pin connector, the ATAPI terminal of the host computer is
connected to this connector.
: This is the power supply terminal.
: These pins are used only for the test in the factory. Don't cover the jumper
block on them.
: The audio digital signal output connector.
: UDMA mode is enabled by covering the jumper block on the 2 pins of the
UDMA jumper terminals.
Default is ON.
(Note 1) In case of using some personal computes, UDMA mode need
to be disable.
SANYO Electric Co., Ltd.
2 3 4