Terminal Description - Sanyo CRD-BPDV2 Owner's Manual

Document No.
(1/3)
1. AUDIO Terminals
The audio signal is output through these terminals. These terminals are used when the sound
board applicable to these terminals, is attached to the personal computer.
2. Jumper Terminals (CS/SL/MA)
SL Jumper Terminals: SL SL SL
To set to Slave mode, cover the jumper block on the 2 pins of the SL jumper terminals.
If the IDE controller of the personal computer supports two devices, set the CD-R drive to Slave
mode. The hard disk drive inside the personal computer is set to Master mode.
MA MA MA MA Jumper Terminals:
To set to Master mode, cover the jumper block on the 2 pins of the MA jumper terminals.
If the IDE controller of the personal computer supports up to four devices, set the CD-R drive to
either a Primary Slave, a Secondary Master or a Secondary Slave mode. Primary or Secondary
is set up by the IDE controller, while Master or Slave mode is set up by covering the jumper
block on the rear of the CD-R drive. The hard disk drive inside the personal computer is set to
Primary Master mode.
CS Jumper Terminals: CS CS CS
If the personal computer is supporting CSEL (Cable Select) signal, cover the jumper block on
the 2 pins of the CS jumper terminals and remain Slave and Master open.
An exclusive interface cable is necessary.
Slave
Document Name

Terminal Description

R-ch
Jumper
block
SANYO Electric Co., Ltd.
GND
Jumper
block
Master
GND L-ch
Use CSEL
Page 9